164 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Chapter 5
SyncServer S6x0 CLI Command Set
history
The command provides a listing of user entries during this session, regardless of
their validity. If a configuration command provides the configuration value(s) on the
same entry line as the command, then the configuration value(s) will be shown in
the history.
Responses are not shown in the history list.
Command Syntax:
history
Example:
SyncServer> history
Response:
0 2015-11-19 18:49:28 set ip address-mode LAN3 ipv4 dhcp
1 2015-11-19 18:49:37 F73
2 2015-11-19 18:49:46 this is not a legal command
3 2015-11-19 18:50:08 show gnss status
4 2015-11-19 18:50:38 set-session-timeout
5 2015-11-19 18:50:47 show-session-timeout
6 2015-11-19 18:50:58 history
The DHCP configuration (item 0) is shown in history because it is accomplished
on the same line as the command.
The configured session timeout value does not appear (item 4) because the CLI
prompts for that value on a response line.
Responses to F73 (item 1) and show... requests (items 3,5) do not appear in
history
Anything entered, even if not valid syntax (item 2) will be maintained in the
history.
To Next Page
Loading...
