Microsemi SyncServer S650 - Set Nena-Format; Show Nena-Format

170 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Chapter 5
SyncServer S6x0 CLI Command Set
show nena-format
Use this command to display the current NENA format for the CLI connection.
Command Syntax:
show nena-format
Example:
s650>show nena-format
Response
NENA format : 8
set nena-format
Use this command to set the NENA format for the CLI connection.
Command Syntax:
set nena-format [0|1|8]
Example:
To set the NENA format to 8 for the serial timing output:
SyncServer>set nena-format 8