152 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Chapter 5
SyncServer S6x0 CLI Command Set
set configuration
Use this command to replaces the current configuration with the factory default
configuration. On SyncServer, user is prompted with “Y” to confirm that they really
want to do it.
set configuration factory
Returning the configuration to factory defaults also includes:
Loss of configured user logins
Loss of configured network settings (addresses, firewall, etc.)
Installed licenses remain installed.
The SyncServer S6x0 reboots as part of this process.
The behavior with this command is identical to using the WebGUI to reset to factory
default (Dashboard > Admin> Configuration Backup/Restore/Reset).
To Next Page
Loading...
