ADMIN Tab
experiences an unexpected failure. They may also be overwritten if memory is low.
Microsemi recommends rotating log files, if needed. Specifying the DNS name or IP address
of a remote server will configure the SyncServer to send a copy of each message received
by the syslog and kernel log daemons to the remote address, if it is reachable. The remote
server can then be configured to filter the messages using its configuration file.
A complete definition of how Syslog is configured may be obtained by consulting the stand-
ard syslog.conf man pages that are widely available on the Internet.
See Admin Logs Config (see "Logs Config" on page 175) default settings
997-01520-02 Rev. G2.......................................................................... Page 63
To Next Page
Loading...
