EasyManuals Logo

Microsens MS453510M User Manual

Microsens MS453510M
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
7
Desktop Installation
Set the switch on a sufficiently large flat space with a power outlet nearby. The
surface where you put the switch should be clean, smooth, level and sturdy.
Make sure there is enough clearance around the switch to allow attachment of
cables, power cord and allow air circulation.
Attaching Rubber Feet
A. Make sure mounting surface on the bottom of the switch is grease and dust
free.
B. Remove adhesive backing from your Rubber Pads.
C. Apply the Rubber Feet to each corner on the bottom of the switch. These
footpads can prevent the switch from shock/vibration.
Power On
Connect the power adaptor to the power jack on the rear panel of the switch. The
other side of power adaptor is connected to the power outlet. The external power
supply in the switch works with DC power in 12V/0.8A. Please check with the
power indicator on the front panel to see if power is properly supplied.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Microsens MS453510M and is the answer not in the manual?

Microsens MS453510M Specifications

General IconGeneral
BrandMicrosens
ModelMS453510M
CategorySwitch
LanguageEnglish

Related product manuals