26 Chapter 3: Using The VeniceF With FireWire
VeniceF
Operator Manual
5 At the Introduction stage of the
installation procedure, observe the
driver release notes and then click
Continue.
6 If your Mac has another hard drive
connected, the Destination Select
stage will let you select another install
location. Otherwise, go to the next
step.
7 At the Installation Type stage, click
Install. (If a password window
appears, enter your password and
continue.)
8 At the Installation stage, click
Continue. Your Mac will start
installing the driver.
9 After the driver has been installed
successfully, your Mac will display the
window shown right at the Summary
stage. Click Restart.
Your Mac will reboot automatically. After it
has restarted it is ready to use.
You must make sure that you Mac has restarted before using the VeniceF
driver you have just installed.
To Next Page
Loading...
