14
Description
5
6
7
8
9
4
UP and DOWN Button
Humidity Set Control buttons
In Setting dehumidifying mode, The humidity level can be set within
a range of 35%RH(Relative Humidity) to 85%RH(Relative Humidity)
in 5% increments. Press and hold the button the humidity drop
continuously.Press and hold the button the humidity rise
continuously.
Fan button
Control the fan speed.Press to select fan speed in three steps-low,
med and high.(On some models The fan speed just can be selected in
two steps-low and high.)The fan speed indicator light illuminates
under dierent fan speed settings. Press and hold the Fan button for
3 seconds to eliminate filter reminder, when the filter light flickers
(On some models).
NOTE: The unit operates for 250 hours, then enter filter clean reminder.
FILL LEVEL button
Control the bucket capacity.Press to select bucket capacity in four
steps-1, 2, 3 and 4. When turn on pump function, the pump indicator
light illuminates and the bucket capacity will be at 4 step.
· Press to initiate the Auto start or Auto stop feature, in conjuction
with the and buttons. When the unit is on, press the Timer
button to activate the Auto stop feature. When the unit is o, press
this button to activate the Auto start feature.
· Press or hold the and button to change the Auto time by
0.5 hour increments, up to 10 hours, then at 1 hour increments up to
24 hours.
· The control will count down the time remaining until start.
· The selected time will register in 5 seconds and the system will
automatically revert back to display the previous humidity setting.
· Turning the unit ON or OFF at any time or adjusting the timer
setting to 0.0 will cancel the Auto start or Auto stop feature.
· When LED display window displays the code of P2, the Auto start
or Auto stop feature will also be cancelled.
Timer button
PUMP feature
(On some models)
Press and hold on the Up/Down buttons 2 second to initiate PUMP
feature.Press and hold on the Up/Down buttons 2 seconds again to
stop PUMP feature. Turn on the PUMP feature, the bucket capacity
cannot be selected and the bucket capacity is at 4 step.
NOTE: When the PUMP feature is actived, it works when the water
is full at 4 step.
Press and hold on the Up/Down buttons 2 seconds to initiate FRESH
feature, and the fresh indicator light illuminates(The fresh indicator
light and the UV indicator light illuminate at the same time on some
models; Only the UV indicator light illuminate on some models ).The
ion generatoris energized and UV(Ultra Violet) feature will help to
purify the air inside.Press and hold on the Up/Down buttons
2 seconds again to stop FRESH feature, and the fresh indicator light
turns dark.
FRESH feature
(On some models)
To Next Page