Service manual for Dryer Machine Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－ 18 －
Electric models - Canada only
- A 120/240 volt, 60Hz AC approved electrical service fused through a 30-ampere fuse or circuit
breaker on both sides of the line is required.
- All Canadian models are shipped with the power cord attached. The power cord should be
plugged into a 30-ampere receptacle.
3.6 Grounding
This appliance must be grounded. In the event of malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a path of least resistance for electric current.
Gas models
- This appliance is equipped with a cord having an equipment-grounding conductor and a
grounding plug.
- The plug must be plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
- Do not modify the plug provided with the appliance: if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
- Never connect the ground wire to the plastic plumbing lines, gas lines, or hot water pipes.
Electric models
- For products sold in the U.S., your dryer has an optional cord with an equipment-grounding
conductor and a grounding plug, which is sold separately.
For products sold in Canada, your dryer is equipped with a cord having an
equipment-grounding conductor and a grounding plug.
- The plug must be plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
- Do not modify the plug provided with the appliance: if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
- If a power cord is not used and the electric dryer is to be permanently wired, This appliance
must be connected to a grounded metal, permanent wiring system, or an equipment-grounding
conductor must be run with the circuit conductors and connected to the equipment-grounding
terminal or lead on the appliance.
WARNING
-Improper connection of the equipment-grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or service representative or personnel, if you are in doubt as to
whether the appliance is properly grounded.
-Certain internal parts are intentionally not grounded and may present a risk of electric shock only
during servicing.
service personnel-do not contact the following parts while the appliance is energized: inlet valve,
control board and temperature-regulating thermistor (located on blower housing).
To Next Page
Loading...
