Service manual for Dryer Machine Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－ 20 －
STEP 3 Connect the gas line (For gas models)
Review the “Gas requirements” section. Remove the pipe thread protective cap.
Apply a pipe joint compound or about 1 ½” wraps of teflon tape over all threaded connections.
- The pipe joint compound must be resistant to the actions of any liquefied petroleum gas.
Connect the gas supply to your dryer. An additional fitting is required to connect the 3/4" (1.9cm)
female thread end of a flexible connector to the 3/8" (1cm) male threaded end on the dryer.
Securely tighten the gas line fitting over the threads.
Turn on the gas supply.
To Next Page
Loading...
