To Next Page
N
nicholas49Aug 3, 2025
What to do if data will not print on Midtronics Test Equipment?
- JJanice MortonAug 3, 2025
If data won't print from your Midtronics Test Equipment, first, press the END button to cancel the print job. Ensure that the IR transmitter and receiver are properly aligned, and then attempt to print the test results again. Also, direct sunlight can interfere with the data transmission, so move the printer and EXP from direct sunlight. If the printed characters are unclear or partially missing, try recharging the battery and reprinting. The printer may be off, as it shuts off after 2 minutes of inactivity. Briefly press the MODE button to turn it on; the green STATUS light should illuminate.
General
