Problem solving guide
100
Problem Possible cause and remedy
The Start at and Finish
at functions are not
available.
The temperature in the oven compartment is too high,
e.g. after a programme has finished.
Open the door and let the oven compartment cool
down.
These functions are not generally available in
maintenance programmes.
This function is not
available at the moment
appears in the display
after selecting the
Descale function.
The steam injection system is faulty.
Call Miele.
Programmes using
moisture injection will
not take in water.
Demo mode is active. You can select menu options in
the display and the sensors, but the steam injection
system pump will not work.
Deactivate demo mode by selecting Settings|
Showroom programme| Demo mode| Off.
The pump for the steam injection system is faulty.
Call Miele.
A noise can be heard
after a cooking
process.
The cooling fan remains switched on after a cooking
programme (see “Settings – Cooling fan run-on”).
After moving house,
the steam
combination oven no
longer switches from
the heating-up phase
to the cooking phase.
Altitude affects the boiling point of water. If you move
house, the appliance will need to be reset for the new
altitude if this differs from the old one by more than
300m.
Adapt the boiling temperature to the altitude of the
new location (see “Settings – Altitude”).
During operation, an
unusually high
amount of steam
leaks out or steam
leaks out from
different places to
usual.
The door is not closed properly.
Close the door.
The door seal is damaged, e.g. cracked, or the door
seal is not inserted correctly.
Call Miele.
The inner pane is so soiled that the seal is not seated
correctly.
Clean the inner pane (see “Cleaning and care –
Dismantling the door”).
To Next Page