Miele FNS 28463 E bb - Page 61

Problem solving guide
61
Message Cause and remedy

lights up red in the
display and an alarm
also sounds.
Indication of an interruption to the power supply:
the temperature in the appliance over the last few
days or hours has risen too high because of a power
cut or interruption to the power supply.
 Touch

 in the display.
The fault message is confirmed:

 goes out and the alarm will stop.
The start screen appears in the display: the warmest
temperature recorded in the freezer will flash for about
1minute in the display. Then the temperature display
will change to the current temperature in the freezer.
You can exit from the flashing temperature display
early:
 Touch the temperature display.
The warmest temperature displayed will disappear.
The display will then revert to showing the current
temperature in the freezer. The appliance will go back
to the last temperature setting when the power is
back on.
 Depending on the temperature displayed, you
should check whether food in the freezer has
started to thaw or has defrosted. If it has, it should
be used as soon as possible. Defrosted food may
only be re-frozen after it has been cooked.