4. Re-setting all parameter
changes back to the factory
settings.
^
Turn the programme selector to the
STOP position f.
^
Switch off the machine.
^
Press and hold ß and 6 at the
same time, and whilst doing so,
switch the machine on with the I-0
button.
The current programme status "P..."
will appear in the display and the p /
6 indicator light will come on.
^ Press 0 as often as necessary or
hold it pressed in until "E33" (pro-
gramming level 33) appears in the
display.
^ Turn the programme selector to any
switch position (except STOP).
00 or PP will appear in the display.
00 = factory setting
(Electronics have not been re-pro-
grammed).
PP = Electronics have been re-pro
-
grammed.
^
If PP is displayed, press ß to
change from PP to 00.
^
Press the 6 button. SP appears.
^
Press 6 again. All values which had
been changed have now been now
reset to the factory settings.
If the hardness level setting in the
water softener had been changed
this will reset to the factory setting of
340 mg/l (19 °d). This will need to be
reset to suit the hardness level in
your area.
Programme changes made to
Programmes A and B (freely pro
-
grammable programmes) cannot be
reversed.
Programming special functions
46
To Next Page
