3. Audible tone (Buzzer)
This special function allows you to
programme a buzzer (lasting up to a
maximum of 30 seconds) for the follow
-
ing functions:
–
Programme end = Constant buzzer
–
Fault warning = Buzzer at one sec
-
ond intervals
–
Removing a test item from the final
rinse water (this function has to be
programmed by a Miele service en
-
gineer)
= 3 x short beeps followed by 2 sec
-
ond pause, then 3 short beeps etc.
^ Turn the programme selector to the
STOP position f.
^ Switch off the machine.
^ Press and hold ß and 6 at the
same time, and whilst doing so,
switch the machine on with the I-0
button.
The current programme status "P..."
will appear in the display and the p /
6 indicator light will come on.
^
Press 0 four times. "E04" (program
-
ming level 4) appears in the display.
^
Turn the programme selector to B. A
number from 20 to 27 will appear in
the display.
20 = Buzzer switched off
21 = Buzzer at end of pro-
gramme (standard setting)
22 = Fault indication
23 = Fault indication and buzzer
at end of programme
24 = Reminder to remove a test
item
25 = Buzzer at end of pro-
gramme and for removing
a test item
26 = Fault indication and buzzer
for removing a test item
27 = Buzzer for all functions
(Programme end, Fault
indication, Removing a test
item).
^
Press ß or hold pressed in, until the
required value appears in the display.
^
Press the 6 button. SP appears.
^
Press 6 again. The change has
been recorded.
Value set:
Note:
The buzzer can be switched off early
by
– turning the programme selector to
the STOP position f,
– pressing the ß button, or
–
interrupting the power supply (e.g.
by opening and closing the door).
Programming special functions
45
To Next Page
