Technical Information
G600 & G800 Electronic Dishwashers
5.14 Door Tension - Adjustment
1. Open the Door.
2. Locate the Spring Adjustment Screw on the left side of the
dishwasher at the top front edge – as shown in Figure 5-17.
3. Use a Torx 20 screwdriver to adjust the Screw as follows:
Clockwise – Tighten.
Counterclockwise – Loosen.
Figure 5-17: Door Tension Adjustment Screw
4. Adjust the Door as follows:
With the Door opened to a 45º position, it
remains stationary (does not continue to open OR close on
it’s own tension)
Repeat step 3 – as needed.
Warning!
Replacement of Door Tension Springs and / or the Door
Panel requires readjustment of the Door Tension.
70
To Next Page
Loading...
