Problem solving guide
125
Insufficient salt/Water softener
Problem Cause and remedy
Refill salt Salt is running low in the water softener.
Refill the reactivation salt before starting the next
programme.
Machine locking out Insuffi-
cient salt
Salt in the water softener is completely depleted and
reactivation is no longer possible. The machine is locked
for further use.
Refill the reactivation salt.
Salt container empty, Pro-
gramme locked
The water softener cannot reactivate because there is
insufficient salt. The machine is locked for further use.
Refill the reactivation salt.
The lock is lifted a couple of seconds after refilling the salt
reservoir. Reactivation will occur automatically during the
next programme sequence.
Salt container lid not properly
closed
The salt container is not closed properly.
Close the container properly.
Salt residues are preventing it from closing.
Remove all residues from the funnel, the lid, and the
seal. Do not use running water as this can cause the salt
container to overflow.
Close the container properly.
The salt container flap has sprung open during a
programme.
When the door is opened, hot steam and chemical
agents can escape!
Open the door and close the container flap.
To Next Page
Loading...
Need help?
General
