Steamer
40
Attaching the Steamer to the steam
connection
Pull back the slider located on the
side of the steam hose plug.
Insert the steam hose plug into the
steam connection on the tower.
Release the slider when it has locked
into place in the steam connection.
The Steamer is now attached to the
steam connection.
You can at any time plug the iron into
the steam connection as an alternat-
ive to the Steamer.
You do not need to switch off the
steam ironing system to do this.
After switching between the iron and
the Steamer, there is a short interval be-
fore the steam is ready. This ensures
that sufficient steam is available.
The Steamer is ready when the mes-
sage Ready for use is shown in the
display.
To Next Page
Loading...
Need help?
General
