Miele PIB 100 - Page 74

Problem solving guide
74
Message Cause and remedy
 Inlet fault, boiler
Switch off/on
There is a fault with the steam system.
 Press the  button to switch the steam ironing
system off and then back on again.
After the cool-down phase, the steam ironing system
will carry out an additional rinse function and attempt
to correct the fault itself. The cool-down phase can
take up to 3hours.
 Remove the residual water drawer if you are
prompted to do so by the appropriate message in
the display.
 Empty and dry the residual water drawer.
 Push the residual water drawer back in the tower
until it clicks into place.
There is a fault with the steam ironing system.
 If the fault message continues to be displayed,
contact Miele Service.
 Pressure switch
fault. Switch off/on
There is a fault with the steam system.
 Press the  button to switch the steam ironing
system off and then back on again.
 If the fault continues to be displayed, contact
Miele Service.
 Boiler fault, warm
Switch off/on
There is a fault with the steam ironing system.
 Press the button to switch the steam ironing
system off and then back on again.
 If the fault continues to be displayed, contact the
Miele Customer Service Department.
The steam generator is soiled with water containing
too much limescale or salt.
 Start a descaling process (see “Starting the de-
scaling process early”). To avoid this problem in
the future, the preset water hardness level can be
set one level higher (e.g., from Level 4 to Level 5,
see “Setting the water hardness”).
 If the fault continues to be displayed, contact the
Miele Customer Service Department.