15
On the left you will find the serial number of your V-Bar and the date
it was manufactured. If you wish to update the software at a later
point in time, you will need this serial number.
The dialogue leads you through the necessary steps for the basic
set-up. In Step 1, choose a pre-defined setup - we call this a Preset -
and load it into the VBar. The components shown in each preset are
intended as recommen-dations only. You can choose other appropriate
equipment.
What’s important later is the correct alignment of the sensor and the
direction of the swash plate movement. Otherwise the preset will not
function correctly. If there is no Preset for your heli brand, please
select a universal preset and read the hints in the pop-up tutorials
carefully.
After loading a preset into the VBar, the diagram at the bottom of the
screen indicates the current assignment of swash plate servos.
If your helicopter does not appear among the listed models, select
the heli symbol at the very top. You will be able to choose among
several different swashplate set-ups. Choose an appropriate set-up
for your helicopter.
To Next Page
Loading...
