Mikro MK2000 - Page 8

iii)
The 3-digit display indicates the value of the item selected.
iv)
If any of the above light is on, the relay is in metering mode. The 3-digit
display indicates the corresponding phase current or earth-fault current.
v)
When this indicator is lighted, the 3-digit display simultaneously indicates the
overcurrent low-set current setting.
vi)
When this indicator is lighted, the 3-digit display simultaneously indicates the
overcurrent time multiplier setting.
vii)
When this indicator is lighted, the 3-digit display simultaneously indicates the
overcurrent high-set current setting.
viii)
When this indicator is lighted, the 3-digit display simultaneously indicates the
overcurrent high-set delay time setting.
MK2000
Page 7