Milesight MS-C5341-X30PC - Set; Call a Preset; Patrol; Pattern

24
Steps:
1.Click on the toolbar of Live View interface.
2.Operate the 3D positioning function

Left click a position of the Live View, the corresponding position will be moved to the
center of the Live View.

Hold down the left mouse button and drag the mouse to the lower right or upper right on
the Live View, you can see a blue rectangle. The corresponding position will be moved to
the center of the Live View and Zoom in.

Hold down the left mouse button and drag the mouse to the lower left or upper left on
the Live View, you can see a blue rectangle. The corresponding position will be moved to
the center of the Live View and Zoom out.

The Bigger the rectangle is, the smaller zoom in/out will be acted.
4.1.3 Set / Call a preset / Patrol / Pattern
A preset is a predefined image position. You can click the call button from the preset list to quickly
go to the desired image position.
Set a preset:
Step1: In the PTZ control panel, select a preset number from the preset list, and you can also
customize the preset name displayed on the screen. The patrol name displayed on the screen will
also be customized if you customize preset name and set a patrol as shown below;