This is the sensitivity for switching Night Mode to Day Mode. When IR Light
Sensor Current Value is higher than this value, it will switch Night Mode to Day
Mode.
The current value of the IR light sensor
With the combination of the High Beam and Low Beam, The IR LEDs technology
has been upgraded to provide better image clarity and quality regardless of the
object distance. Also, the Low Beam and High Beam's brightness can be adjusted
manually or automatically on the basis of the Zoom ratio. Moreover, with the IR
anti-reflection panel, the infrared light transmittance is highly increased.
Support to set the strength of the IR to Auto Mode or Customize to achieve the
best effect.
Speed Dome has 8 LED lights, 4 are High Beams and 4 are Low Beams.
And Mini PTZ Bullet has 4 LED lights, 2 are High Beams and 2 are Low Beams.
Adjust the light strength of Low-Beams LED light level from 0 to 100.
Adjust the light strength of High-Beams LED light level from 0 to 100.
The current value of Low-Beams LED and High-Beams LED light value
With this option enabled, the camera will refocus when switching between day
mode and night mode.
Select indoor or outdoor mode to meet your needs.
There are three options available, you can select one to meet your need
Off: Keep the image in normal direction
Clockwise 90°: Rotate the image by 90° clockwise
Anticlockwise 90°: Rotate the image by 90° anticlockwise
There are four options available, you can select one to meet your need
Off: Keep the image in normal direction
Rotating 180°: Upside down the image
Flip Horizontal: Flip the image horizontally
Flip vertical: Flip the image vertically
This function is only for Mini PTZ Dome. If Mini PTZ Dome is equipped with a
Smoked Dome Cover, enable this function to display a normal image.
Note:
The PTZ Network Camera which with optical zoom of 20X or above supports Zoom Limit function.
Take the 20X Mini PTZ Dome camera as an example:
To Next Page
Loading...
