Milesight MS-C5341-X30PC - Page 50

44
Parameters
Function Introduction
Get IPv4 Address
Automatically
Get an IP address from the DHCP server automatically.
Use fixed IP address
IPv4 Address: It is used to identify a network camera on the network;
IPv4 Subnet Mask: It is used for identifying the subnet where the network camera
is located;
IPv4 Default Gateway: It is the default router address;
Preferred DNS Server: The DNS Server translates the domain name to IP address;
IPv6 Mode: Choose different mode for IPv6: Manual/Route Advertisement/
DHCPv6;
IPv6 Address: It is used to identify a network camera on the network;
IPv6 Prefix: Define the prefix length of IPv6 address;
IPv6 Default Gateway: The default router IPv6 address.
MTU: Maximum Transmission Unit. The default value is 1500. You can customize
the value from 1200 to 1500 as needed
Note:
The Test button is used to test if the IP is conflicting.
HTTP
Table 4-4-9 Description of the buttons