Milesight UC300 - Page 15

15
UCS-2: send Unicode characters and suit for more languages like Chinese,
Korean and Arabic, can contain up to 70 characters.
NTP Server
Enter the NTP Server's IP address or domain name. After registered to
network, the device will sync the device time from this server. Default:
www.ntp.org
Change Password
Change the password to loggin ToolBox and SMS password validation.
Application Settings:
Go to “Application -> Application” to configure the settings to send data to corresponding
servers. About the MQTT topics, please refer to the UC300 Cellular Communication Protocol.
Parameters
Description
Application Mode
Select from “Milesight IoT Cloud”, “AWS”, “TCP”, “UDP”, and “MQTT”.
Reporting Interval
(s)
The interval of reporting interface data. Default: 1800s, Range: 10-64800s
Note: for Milesight IoT Cloud mode, the reporting interval should be
configured on the cloud webpage.
Milesight IoT Cloud
Keep Alive Interval
(s)
After connected, the device will send heartbeat packet regularly to keep alive.
Default: 200 s, Range: 1-3600 s
AWS
Server Address
Fill in the AWS server domain name which the data sends to.
Keep Alive Interval
After connected, the device will send heartbeat packet regularly to keep alive.