Miller 22A - Installation - Continued; Equipment Connection Diagrams; 14-Pin Plug, Gas, and Volt Sense Lead

OM-193472 Page 15
1 CV Welding Power Source
With 24 VAC Power
2 CV Welding Power Source
Without 24 VAC Power
3 115 Volts AC /24 Volts AC
Power Adapter
4 14-Pin Control Cord
5 Weld Cable (Required)
6 Work
5-2. Equipment Connection Diagrams
115VAC
Contactor
3
2
6
6
5
5
4
1
4
1 Gas Hose With 5/8-18 Right-
hand Thread Fittings
(Customer Supplied)
. Shielding gas pressure not to
exceed 100 PSI (689 kPa).
2 14 Pin Plug PLG2
Use plug to make connection to
welding power source.
3 Optional Volt Sense Lead
(Part Of Meter Option)
! Weld voltage is present at
voltage sensing clamp
when wire feeder and weld-
ing power source are on.
This condition exists even if
wire feeder lights and
meters are off.
Turn off wire feeder or weld-
ing power source before
handling or moving voltage
sensing clamp.
Connect to work.
4 Power Switch
5-3. 14-Pin Plug, Shielding Gas And Optional Volt Sense Lead
802 349-A
Tools Needed:
1
3
4
5/8, 11/16 in.
2