OM-252 052 Page 5
3-2. On Button And Low Battery Indicator
The auto-darkening lens turns
on (darkens) automatically
when welding begins and turns
off when welding stops.
1 Reset Button
Press Reset button to check if the
lens is working properly.
When the Reset button is pressed,
the lens should darken twice and re-
turn to the clear state. Do not use
the helmet if the lens does not func-
tion as described. (See Section 9,
Troubleshooting.)
2 Low Battery Indicator
The low battery indicator lights
when 2−3 days of battery life re-
main.
If battery power is low, replace with
AAA Alkaline Batteries only (see
Section 6).
1
2
3-3. Lens Delay Control
1 Lens Delay Control
The lens delay control is used to
adjust the time for the lens to switch
to the clear state after welding.
The delay is particularly useful in
eliminating bright after-rays pres-
ent in higher amperage applica-
tions where the molten puddle re-
mains bright momentarily after
welding. Adjusts from slow to fast.
1
To Next Page
Loading...
Need help?
General
