To Next PageTo Next PageWhat to do if Miller Welding Accessories motor doesn't run on trigger press?
If the motor in your Miller Welding Accessories does not run while pressing either gun trigger, check the continuity of the gun trigger switch and leads. Repair or replace the welding gun. Also, check the trigger filter board PC8 RC18, replacing it if necessary. Check the motor board PC1 RC8 and RC, and replace if necessary.
Why is my Miller Welding Accessories motor running slowly?
If the motor runs slowly in your Miller Welding Accessories, check for the correct line voltage. Inspect the push-pull gun WFS potentiometer and control cable, replacing if necessary. Verify the functionality of the encoders on the display board. Check the motor board PC1 and connections, replacing if necessary.
General| Input Voltage | 24 VAC |
|---|---|
| Input Frequency | 50/60 Hz |
| Weight | 46 lb |
| Output Voltage Range | 14 VDC |
| Wire Feed Speed Range | 50 - 780 IPM |
| Dimensions | 15.5 in |
