Quick start
7
Dispense pure water
Before dispensing pure water
It is a good practice to always recirculate water before dispensing. The recirculation lasts 3 minutes
and is triggered every 60 minutes.
To do this, press on the recirculation icon , this also refreshes the water quality parameters:
• EDI resistivity
• Temperature
When connected to a storage tank, always make sure there is enough water present before
dispensing. This information is always displayed on the main screen.
Dispensing pure water in free ow mode
There are several options to dispense pure water:
Manual Dispensing Full ow
To start low ow dispensing, turn the dis-
pense wheel one notch counter-clockwise.
+
To start dispensing in full ow, press the
wheel once and quickly release.
Adjust ow rate Stop
To increase the ow rate, keep turning the
wheel counter-clockwise until full ow is
reached. To decrease the ow rate, turn the
wheel clockwise.
Low ow High ow
_
+
To stop any ongoing dispensing, press down
on the wheel one additional time or rotate
the wheel clockwise until no more water ows
from the dispenser.
To Next Page
Loading...
