Millipore Helicon S10 - Joining the Cartridges

Helicon S10/S40 Spiral Cartridges Installation Guide 13
Joining the Cartridges
Figure 7 shows how two S40 cartridges are connected, using a cartridge
connector (included in the S120 Cartridge Hardware Kit).
Figure 7. Two S40 Cartridges Connected by a Cartridge Connector
1. Re-lubricate the O-rings with glycerin, to facilitate joining the three cartridges
together.
2. Using a gentle twisting motion, join the cartridges together:
a. Push cartridge #2 over the connector extending from the outlet end of
cartridge #1.
b. Push cartridge #3 onto the connector extending from the outlet end of
cartridge #2.
Housing sleeve
Anti-telescoping device
(ATD)
Cartridge
Cartridge
Cartridge connector
C
h
evron
(limited
by-pass)
seal
Permeate tube