Millipore Helicon S10 User Manual

Helicon
™
S10/S40
Spiral Cartridges
Installation Guide
NOTICE
The configuration of Helicon
™
S40 cartridges has been changed:
the limited by-pass seal (the “chevron”) has been moved to the inlet end.
Please follow these installation instructions carefully.

Millipore Helicon S10 Specifications

General

Model	Helicon S10
Brand	Millipore
TOC	< 5 ppb
Bacteria	< 1 CFU/mL
Endotoxins	< 0.001 EU/mL
Output Water Type	Type I ultrapure water
Resistivity	18.2 MΩ.cm
Power Supply	50/60 Hz

Summary

Introduction

Safety and Environmental Compliance

S10 Cartridge Installation

S10 Flushing and Cleaning

Procedure for flushing and cleaning S10 cartridges using purified water and NaOH solution.

S10 Integrity Testing

Configuration and steps for performing integrity testing on S10 cartridges using gas pressure.

S40 Cartridge Installation

S40 Configuration Change Notice

Notice regarding the changed configuration of Helicon S40 cartridges and the chevron seal position.

S120 Cartridge Installation

S120 Configuration Change Notice

Notice regarding the changed configuration of Helicon S40 cartridges for S120 housing.

Joining the Cartridges

Steps for connecting multiple S40 cartridges using cartridge connectors and ATDs.

Installing the Cartridge Assembly in the Housing

Procedure for installing the assembled cartridges into the S120 housing sleeve.

S40/S120 Flushing and Cleaning

S40/S120 Integrity Testing

Product Ordering Information

Technical Assistance

Standard Warranty