Millipore Helicon S10 - Installing the Cartridge Assembly in the Housing

14 www.millipore.com
Installing the Cartridge Assembly in the Housing
Figure 8 shows the installation of three S40 cartridges in an S120 housing, using
the S120 Cartridge Hardware Kit.
Figure 8. Installation of three S40 cartridges in an S120 housing
Outlet header
Clamp
Cartridge #2
Permeate port
Inlet header
Housing sleeve
Cartridge #1
Cartridge #3
Gasket
Clamp
ATD
Permeate plug
Chevron seal
Chevron seal
Cartridge connector
Permeate connector
Permeate tube
Chevron
(limited by-pass)
seal
ATD
Cartridge connector
Anti-telescoping device
(ATD)
Gasket