Milltronics COMPU-M User Manual

PARAMETER ENTRY
Specific application information must be entered into the appropriate Compu-M memory locations. These
locations are identified by a
parameter number (P#). The information entered is referred to as a parameter
value
(value). To enter specific application information the operator accesses the desired parameter, views
the parameter value on the LCD display, and then accepts or alters the current parameter value.
DIRECT PARAMETER ACCESS
To directly access any parameter, press
"PAR". If [P ] is presently displayed, the Compu-M is currently
prompting the operator to enter a parameter number. Enter the desired parameter number as listed on the
Compu-M front cover or in Parameters. If
[P# ] is displayed the Compu-M is currently in the access mode.
e.g. press
"PAR"
[P ] will be displayed, P01 is desired
press
"O" and then "1"
[P01 ]
will be displayed
AUTOMATIC PARAMETER ACCESS (APA)
Values for parameters: P01, 02, 0, 1, 2, 3, 4, 5, 6, 7 must be entered to complete basic programming. Upon
accessing any of these parameters, pressing
"ENTER" will cause the Compu-M to enter the current parameter
value displayed and automatically access the next parameter in this loop.
e.g.
[P01 1] is displayed
press
"ENTER"
[P02 1]
will be displayed
VIEW PARAMETER VALUES
To view a parameter’s contents, access the desired parameter as previously described. Automatically
accessed parameter values are immediately displayed. Direct accessed parameters will require
"ENTER" to
be pressed in order to view the current value.
e.g.
[P50 ] is displayed
press
"ENTER"
[P50 #]
will be displayed
Parameter Number (P#)
Parameter Value
P## ####
PL-516 24

Milltronics COMPU-M Specifications

General

Brand	Milltronics
Model	COMPU-M
Category	Control Systems
Language	English