PROGRAMMING CHART
P01 MODE: [ ] 1 = belt scale, 2 = flowmeter
P02 OPERATION: [ ] 1 = load cell, 2 = LVDT
P0 UNITS: [ ] rate display, 1= MTPH, 2 = KG/H, 3 = LTPH,
4 = STPH, 5 = LB/H
P1 DESIGN RATE: [ ] from design data sheet
P2 LOCAL TOTAL: [ ] registration multiplier, refer to parameters
P3 REMOTE TOTAL: [ ] registration multiplier, refer to parameters
* P4 BELT SPEED: [ ] from design data sheet m/sec or ft/min.
* P5 SPEED CONSTANT: [ ] from design data sheet
* P6 BELT LENGTH: [ ] from design data sheet or as measured, m or ft
P7 TEST LOAD/RATE: [ ] KG/M or LB/FT (belt scales)
MTPH,KG/H,LTPH,STPH or LB/H (flowmeters)
ZERO CALIBRATION [ ] observed Initial zero referencecount
SPAN CALIBRATION [ ] observed Initial span reference count
P8 MANUAL SPAN ADJUST: [ ] material test % span error
P9 FACTORING: [ ] test weight correction 0 = no, 1 = yes
P10 TOTAL DROPOUT: [ ] totalizer cutoff point %
P11 DAMPING: [ ] local display and rate output, from 1 to 9999
P12 RATE OUTPUT: [ ] 1 = 4-20 mA, 2 = 0-20 mA
P16 TOTALIZER RELAY: [ ] on-time closure duration, from 1 to 9
* P17 SPEED CONSTANT ADJUST: [ ] actual belt speed m/sec or ft/min
P18 RATE OUTPUT DAMPING: [ ] if other than P11 value, from 0 to 9999
P20 ALARM RELAY: [ ] 0 = off,
1 = rate set point: Low [ ] High [ ]
2 = fixed rate
3 = auto zero
* 4 = speed set points: Low [ ] High [ ]
P21 AUTO SCROLL DISPLAY: [ ] 0 = off, 1 = alternating
P24 LINEARIZER: [ ] 0 = disabled 1 = enabled
L1 [ ] L2 [ ] L3 [ ]
L1c [ ] L2c [ ] L3c [ ]
P25 ZERO LIMIT: [ ] 0 = 12.5%, 1= 2%
P30 CALIBRATION DURATION: [ ] utilized for zero or span calibrations, from 1 to 99
P67 DIRECT ZERO ENTRY: [ ] 0 = disabled 1 = enabled
P68 DIRECT SPAN ENTRY: [ ] 0 = disabled 1 = enabled
* parameter applicable to belt scale applications only, P01 = 1
PL-516 75
To Next Page
Loading...
