• Always use safety shoes with steel toecaps and oil resistant soles.
• Do not operate the machine while wearing loose or baggy clothes.
• Always completely fasten buttons and hooks on the arms of clothing to avoid
danger of entanglement in machine mechanisms.
• Do not operate the machine under the influence of drugs or alcohol.
• If wearing gloves to load or unload parts, be sure the machine is in
emergency stop mode.
2. WARNING
• Close all doors and covers of the CNC unit, operation panel and electrical
panel to prevent damage from water, chips, and oil.
• Emergency stop the machine and turn off the main power during electrical
storms.
• Check all safety covers regularly to make sure they are properly fitted and not
damaged.
• Always obtain assistance when handling loads beyond your ability.
• Do not adjust coolant nozzles while the machine is in operation.
• Do not remove or interfere with any machine safety devices.
• Do not wipe the work piece with a rag while the spindle is rotating or the
machine is in motion.
• Always stop the machine before removing or inspecting a tool.
• Tools and tooling can be very sharp. Take care when handling.
• Never place an object or your hand in the carousel or tool changer without
putting the machine in emergency stop.
• Never place anything between the machine spindle and tool changer.
• Never use additional clip-on or poorly secured lighting.
3. CAUTION
• Do not allow chips to accumulate during heavy cutting.
• Never use compressed air to clean the machine bed.
• Never wear gloves while operating panel switches.
4
To Next Page
Loading...
Need help?
General
