Milltronics ML Series User Manual

2-Speed Transmission Maintenance – ML35-40 Only Speed Transmission Maintenance – ML35-40 Only
48
Oil drain Sight window
Oil fill ca
p
2-Speed Transmission 2-Speed Transmission
P
c
Periodically inspect the oil level by
checking the sight window.
eriodically inspect the oil level by
hecking the sight window.
R
m
th
Replace gearbox oil after first three
months, then every six months
thereafter.
eplace gearbox oil after first three
onths, then every six months
ereafter.
F
d
D
H
For ambient temperatures 90
degrees F and below, use Mobil
DTE24 (VG32), Shell Tellus C32, BP
HLP32, or equivalent hydraulic oil.
or ambient temperatures 90
egrees F and below, use Mobil
TE24 (VG32), Shell Tellus C32, BP
LP32, or equivalent hydraulic oil.
F
9
e
M
For ambient temperatures above
90 degrees F, use synthetic
equivalent of above listed oils.
or ambient temperatures above
0 degrees F, use synthetic
quivalent of above listed oils.
C
o
Mobil DTE24 = Mobil SHC 524. obil DTE24 = Mobil SHC 524.
Check with your local supplier for
other equivalent synthetic oils.
heck with your local supplier for
ther equivalent synthetic oils.
Q Quantity = 30 Liters (8 US Gallons) uantity = 30 Liters (8 US Gallons)
_
__________________________
_
Oil change procedure
Using a suitable container, drain the
oil (see oil drain).
Replace the drain plug.
Fill with recommended oil, and then
replace the oil fill cap.
Check for leaks and address as
necessary.

Milltronics ML Series Specifications

General

Brand	Milltronics
Model	ML Series
Category	Lathe
Language	English