Parameters P-23 through P-33 are used specifically for pump applications.
Refer to Applications \ Pump Control Applications.
P-23 submersible transducer
enter: 0 = normal ST- series transducer ( F )
1 = submersible transducer
P-24 relay 1 pump log *
P-25 relay 2 pump log *
P-26 relay 3 pump log *
P-27 relay 4 pump log *
P-28 relay 5 pump log *
These parameters are divided into three levels of subparameters:
» " service hours " log
» " pump starts " log
» " ratio " setpoint
Access is made by scrolling through the levels.
press display will show
*
" pump starts "
initial access ( service hours )
PL-443 7 – 4
To Next Page
Loading...
