Milnor E-P Express - How to Add or Change a Formula; Quick Reference for E-P Express Programming

22
Pellerin Milnor Corporation
2.3.3 How to Add or Change a Formula
BNCXUP12.C04 0000206725 A.5 D.3 1/2/20 1:35 PM Released
Washer extractors with the Milnor
®
E-P Express
®
control system have the capacity for up to 30
unique wash formulas. The space for these formulas is allocated in memory whether or not the
formulas are actually used.
The user interface employs similar procedures for creating a new formula and for changing an ex-
isting formula. Both procedures are detailed below, in Section 2.3.3.3 : How to Create a New For-
mula, page 23 and Section 2.3.3.5 : How to Change a Formula, page 24 . The control system will
inform the person programming the machine whether the selected formula has already been
programmed.
2.3.3.1 Quick Reference for E-P Express
®
Programming
BNCXUP12.T01 0000206804 A.5 D.3 A.7 1/2/20 1:35 PM Released
This part of this document briefly describes how to program a wash formula. For a more detailed
description of navigating through the programming capabilities of this controller, see Section
2.3.3.2 : Moving through the Operations and Decisions, page 23 . More information on creating
and deleting formulas is in Section 2.3.3.3 : How to Create a New Formula, page 23 and Section
2.3.3.4 : How to Delete a Formula, page 24 , respectively. Section 2.3.3.5 : How to Change a For-
mula, page 24 describes how to modify an existing formula, and explains each programming
decision.
1. Apply power to the machine.
2. After the normal power-up display and start-up safety delay, turn the Run/Program key-
switch to the Program position (
).
3. Scroll (
/ ) to ADD/CHANGE FORMULA and press the Next button ( ) to confirm
your choice.
4. Scroll (
/ ) to an unused formula number (01 through 30) to add a new formula. The
cursor will flash on “CHANGE.”
5. Press the Next button (
) to confirm your choice.
6. Select the type of step (TT) from the available options (00 through 14).
TIP: At this point, you can delete the formula by setting the type of step for Step 01
to “00.”
7. Press the Next button (
) to confirm your choice and advance to the next decision (MMQ).
8. Scroll the first (tens) digit to the desired value, then press the Next button (
) to confirm
your choice and advance to the next digit.
9. Scroll the second (units) digit to the desired value, then press the Next button (
) to con-
firm your choice and advance to the next digit.
10. Scroll the third (quarter-minutes) digit to the desired value, then press the Next button (
)
to confirm your choice and advance to the next decision.
Programming