Pellerin Milnor Corporation 67
Figure 16. Wiring Diagram for Cable to Connect a Machine to a Serial Memory Storage Device
Receptacle
Legend
A...Receptacle on machine (with male pins). Pin functions are as follows: 1&2=Se-
rial low. This application only uses Pin 1; 3&4=Serial high. This application
only uses Pin 3; 6&9=Ground. This application only uses Pin 9; 5&7=Not used
in this application; 8=+5VDC. Provides power to memory storage device.
B...Plug on cable (with female pin sockets)
C...Memory storage device (front panel may be different)
D...Tie shield on this end of cable to ground. Leave unconnected on other end.
Plug and Storage Device
BNCUUI01 / 2018303
BNCUUI01 0000196633 A.6 1/2/20 1:30 PM Released
5.4 Printer Requirements and Settings
BNCUUI01.C01 0000196632 A.5 A.6 1/2/20 1:30 PM Released
NOTICE: Because of the many differences among printer makes and models, Milnor
®
cannot ensure suitability or troubleshoot printers other than those described in this docu-
ment (or certain older approved models), with the required interface cable.
5.4.1 Cable Requirements
BNCUUI01.R01 0000196631 A.5 A.6 1/2/20 1:30 PM Released
The printer must be connected to the printer port on the machine using the appropriate one of the
following Milnor interface cables:
Table 13. Milnor Printer Cables
Printer Cable Part Number Description
10YMK2PNTR
100-formula washer-extractor, dryer, extractor, and Miltron
(CBW
®
) controllers
10YCBWPNTR
Non-serial Miltron (CBW) controller
08MPSERCBL
Mentor
®
(CBW) and Mildata
®
controllers
Supplemental Information
To Next Page
Loading...
