30
Pellerin Milnor Corporation
Table 6. Chemical Signals and Supplies
Chemical Signal
(from display)
Chemical Name
1
(usually detergent)
2
(usually bleach)
3
(usually sour)
4
(usually softener)
5
(usually starch)
2.3.4 How to Configure the Controller
BNCXUP12.C25 0000208706 A.5 D.3 A.4 1/2/20 1:35 PM Released
Because the microprocessor control system used in this machine is capable of multiple languages
and operating with many different chemical injection systems, each machine must be configured.
This configuration informs the microprocessor of what language to use for displaying operator in-
formation and the duration of the inject time for chemical one.
CAUTION: Configure Data may be Lost — If the controller loses power either acci-
dentally or intentionally while in the Configure mode, all configuration
data may be corrupted. Reconfigure the controller at installation and any
time a memory error is detected.
2.3.4.1 Moving through the Configure Screens
BNCXUP12.C26 0000208705 A.5 D.3 A.7 1/2/20 1:35 PM Released
Display or Action Explanation
PROGRAM 2 MENU
CONFIGURE
This display indicates that the controller is in Program mode with
the Configure menu selected for access.
Accesses the Configure menu and displays the first configuration
decision.
LANGUAGE ?
0=ENGLISH 0
The language option that appears here may vary according to how
the controller was last configured.
CHEM 1 INJ TIME: SSS
FORMULA 01 030
The value that appears here may vary according to how the con-
troller was last configured. These values are always reset to 30
seconds whenever the standard formulas are restored, as described
in Section 2.3.5 : Restoring the Standard Formulas, page 33 .
Accepts the displayed selection.
Accepts the displayed selection and reverts to the previous config-
ure decision.
Programming
To Next Page
Loading...
