MIMAC MAXIDROP TWIST - Page 50

48
www.mimac.com
STATISTICS
Parameter
Description
Number of dosages (Partial)
Number of dosages made after resetting the data. To reset the data, hold
the "R" icon for at least 2 seconds. Only a user of "ADVANCED" or higher
level can perform the reset.
Number of trays (Partial)
Number of trays made after resetting the data. To reset the data, hold the
"R" icon for at least 2 seconds. Only a user of "ADVANCED" or higher level
can perform the reset.
Working time (Partial)
Working time of the machine made after resetting the data. To reset the
data, hold the "R" icon for at least 2 seconds. Only a user of "ADVANCED"
or higher level can perform the reset.
Number of dosages (Total)
Number of dosages made after resetting the data. To reset the data, hold
the "R" icon for at least 2 seconds. Only a user of "SELLER" or higher level
can perform the reset.
Number of trays (Total)
Number of trays made after resetting the data. To reset the data, hold the
"R" icon for at least 2 seconds. Only a user of "SELLER" or higher level can
perform the reset.
Working time (Total)
Working time of the machine made after resetting the data. To reset the
data, hold the "R" icon for at least 2 seconds. Only a user of "SELLER" or
higher level can perform the reset.
ADVANCED
Parameter
Description
Reset PLC & HMI
It is used for cancelling the memory both from the PLC and the touchscreen,
bringing them back to the original status.
Service
Access allowed only to a vendor level user, it allows to make advanced
modifications to the SERVICE page.
Manage tray presence
sensor
Allows to disable the operation of the tray presence sensor.
Demo mode enable
Enables the machine operation in DEMO mode, that is to say with variations
of the program after each tray.
Programs running in demo
mode
Selects the programs’ interval to carry out while in the DEMO mode.
Modbus dropping inverter
Allows to enable (ON) or disable (OFF) the Modbus protocol management of
the respective inverter through the touchscreen.
It can be used temporarily in case a malfunction of the communication port
of an inverter occurred. Useful to guarantee operation continuity of the
machine till the inverter is replaced.
Modbus lifting system
inverter
Modbus wire-cut inverter
Modbus lifting cam inverter
SERVICE
Parameter
Description
VNC
Enables the HMI remote connection.
Password
Password to enter after starting the HMI remote connection.
Teleservice
Starts the remote-assistance mode.