Maximum wire-cut stop
delay
Maximum waiting time before the wire cutting system stop command is sent.
Wire cutting speed below which the maximum delay in sending, the stop
command is applied.
Wire cutting speed above which the stop command is sent without applying
any delay.
Distance (in height) between the pump type head and the machine zero.
Wire-cut die offset roller
Distance (in height) between the roller type head and the machine zero.
Minimum settable value of the Table distance parameter in wire-cut product.
Lap pulses of slow spindle
Number of pulses the nozzle rotation drive card sends to the PLC for each
turn of the slow reducer spindle.
Revolutions per minute of
slow spindle
Maximum number of revolutions the slow reducer spindles makes in a
minute.
Teeth number on machine
sprocket
Number of teeth of the gear assembled to the reducer.
To Next Page
Loading...