EasyManuals Logo

MIMAKI CG-FX SERIES Support Document

MIMAKI CG-FX SERIES
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
WTQA2011-0676 - 1 -
1. Register mark detection after sheet detection
(1) Are the register marks created
with FineCut?
Register marks created with
Illustrator cannot be read.
Only register marks created with
FineCut can be detected.
(2) Is the sheet white and the black
register marks?
Colored sheets and colored register
marks cannot be detected.
(3) Is there any bleeding on the
register marks? Are you
enlarging the image when
printing?
When printing the image, do not
enlarge or reduce it.
Set the line width of the register marks to between 0.5mm and 1.0mm.
(4) When detecting registration
marks on the plotter, is the
starting position for registration
mark detection correct?
Align the lower-right register mark (TP1) in the shape of a triangle with
the center of the registeraion mark detection starting position.
1
st
point
1
st
point
1
st
point
1
st
point
assume TP1 (lower-right registration
mark) as a triangle and align the
light pointer with its center.
When “TP1” is displayed…

Other manuals for MIMAKI CG-FX SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MIMAKI CG-FX SERIES and is the answer not in the manual?

MIMAKI CG-FX SERIES Specifications

General IconGeneral
BrandMIMAKI
ModelCG-FX SERIES
CategoryPlotter
LanguageEnglish

Related product manuals