MIMAKI JFX 200-2513 - a. Setting Glossy Print

- 13 -
a. Setting Glossy Print
1.
In the job list, select the clear ink job.
• Click the “Properties” icon.
• Click the [Setup] button in the [Job Attribute] field.
2.
Select the [UV Mode] tab.
• Clear ×2 slot
Make the settings as follows.
(1) Select “Glossy Print” in the mode list on the left
side.
(2) Set “0” for [Additional UV irradiation].
(3) Click the [OK] button.
• Clear ×1 slot
Make the settings as follows.
(1) Select “Glossy Print” in the mode list on the left
side.
(2) Set “0” for [Additional UV irradiation].
(3) Click the [OK] button.
3.
Thumbnail of attribute becomes a "Clear
(Glossy)".
• When "Print bottom clear liquid" is enabled, the base
clear is printed on top of the color image, and then
print the glossy clear on it.
• In the case of clear × 1 slot
Glossy print cannot be obtained without printing a
base clear on top of the color image, so "Print bottom
clear liquid" cannot be disabled.
• In the case of clear × 2 slot, it will be glossy without
printing a base clear on top of the color image.
If some media do not get glossy , please enable
"Print bottom clear liquid".
(1)
(2) (3)
(1)
(2) (3)
Glossy clear
Base clear
Color image