- 16 -
c. Setting Emboss Print
1.
In the job list, select the clear ink job.
• Click the “Properties” icon.
• Click the [Setup] button in the [Job Attribute] field.
2.
Select the [UV Mode] tab.
• Make the settings as follows.
(1) Select “Emboss Print” in the mode list on the left
side.
(2) [Illumination]: Set “100%”.
(3) [Number of printings]: Set this according to the
thickness of the embossing. (See “Hint!” below
for rough calculation of the number of printings
for the thickness).
(4) Click the [OK] button.
3.
Thumbnail of attribute becomes
a“Clear(Emboss)”.
• After you have set Emboss Print, the clear ink job will be printed the specified number of times
after the color job is printed, regardless of the [Priority policy] settings on the [Composition]
screen.
• The table below gives rough correspondences between the thickness of the embossing and the
number of additional times (after the first printing) that the clear ink is printed over the color
image.
These values are for when 600x900 dpi output resolution is set.
• When you specify Emboss Print, make sure that there is ample head clearance.
• If you set just Emboss Print, the finish will be matte. See P. 19 for the settings to make in order
to obtain a glossy print result.
LH-100 clear ink LUS-120 clear ink
Number of times clear ink job is
printed, the clear ink job is printed
the specified number of times.
Embossing thickness
[mm]
Embossing thickness
[mm]
2 0.07 0.05
4 0.13 0.12
6 0.19 0.21
8 0.25 0.26
10 0.31 0.33
15 0.46 0.50
20 0.61 0.66
To Next Page
Loading...
