MIMAKI JFX500-2131 - Page 17

- 17 -
In the case of [C.Printing a special clear ink image]:
1.
Refer P. 10~11 “C.Printing a special clear ink image”, keep up the setting
of mono color replacement.
2.
Choose the job of clear ink
from the job list.
• Click the “Properties” icon.
• Click the [Setup] button in the [Job
Attribute] field.
3.
Select the [UV Mode] tab.
• Make the settings as follows.
(1) Select “Glossy Print” in the
mode list on the left side.
(2) Additional UV irradiation: 1 time
Irradiation 1Illuminance.: 100%
(3) Click the [OK] button.
4.
Job list of attribute becomes a "Clear
(Glossy)".
5.
Choose the job of clear ink from the job list.
• Click the [Special plate] icon.
6.
Make the settings as follows.
(1) [Special Color]：Ink = Clear
Clear= Select “40%”.
(2) [Created area]: Select “Valid Pixel”.
(3) Set [Composite automatically]: OFF.
(4) Click the [Create] button.
• Concentration of clear ink of base
clear is 40%.
(2)
(1)
(3)
(1)
(3)
(4)
(2)