MIMAKI JV150-160 - Rear Side and Right Side of the Machine

1-4
Chapter 1 Before Use
Rear Side and Right Side of the Machine
AC inlet
Connect the power cable to the AC inlet.
Clamp lever (rear)
Interlocks with the clamp lever in
the font of this machine.
USB 2.0 connector
This is USB2.0 interface connector.
Main power switch
Turns on/off the main power for this machine. Leave
the main power turned on to prevent ink clogging.
Roll rests
Rests for placing the roll on when installing roll media.
Vent filter box
Vents the ink mist that
occurs during printing.
Roll holders
Putting this into the paper core
(right and left) of a roll media, hold
the media. It supports the paper
core of 2 inch and 3 inch.
LAN connector
Please use this connector when you use netwark
function.