MIMAKI JV150-160 - Chapter 2 Basic Operations

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media .............................................2-4
Adjusting the Head Height .......................... 2-4
Setting a roll media ..................................... 2-5
Take-up device ............................................ 2-8
Setting leaf media ....................................... 2-8
Changing the printing origin ........................ 2-9
Preparing for the Heaters ............................2-10
Changing the Temperature Settings for
the Heaters ................................................ 2-10
Test Printing ................................................2-10
Test Printing .............................................. 2-11
Perform test printing with the normal test
pattern ....................................................... 2-11
Perform test printing with the test pattern
for checking white ink ................................ 2-11
Head Cleaning ............................................2-12
About head cleaning ..................................2-12
Perform head cleaning depending on the
test printing result ......................................2-12
Setting of Media Correction .........................2-13
Setting of Media Correction ......................2-13
If the Positions of Dots Shift... .....................2-13
Printing Data ...............................................2-14
Starting a Printing Operation .....................2-14
Stopping a Printing Operation ....................2-14
Deleting Received Data (Data Clear) ........2-14
Cutting a media ..........................................2-14
Chapter 2
Basic Operations