MIMAKI JV5 Series Maintenance Manual

© 2009 MIMAKI ENGINEERING CO.,LTD.
4.3.4 P.1
1
2
3
4
5
6
7
8
R.1.0
Maintenance Manual > Adjustment Items > Mechanical Adjustment > Adjustment of the Wiper Height
Model CJV30/TPC Issued 2008.08.04 Revised F/W ver. 1.00 Remark
1.0
Rev.
4.3.4 Adjustment of the Wiper Height
 Outline
 Procedure
1. Loosen the wiper height adjusting screws (x2), and temporarily
adjust the screws until the thickness gauge is 8mm.
2. Loosen the screws (x2) on the head cover front, and then tighten
the screws while holding the height adjustment lever in the lowest
position to fix the head in place.
3. Move the head, and adjust the wiper so that there is approximately
1.5 mm from the nozzle surface.
W-BKT spacer
8 mm
1.5 mm
Nozzle surface
Wiper

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English