© 2009 MIMAKI ENGINEERING CO.,LTD.
Selection of drawing type
[]: Square and straight line
[]: Broken line
[FUNCTION]: Radial lines consecutively
[REMOTE]: Squares consecutively
#PEN PRESSURE
0g = 0
#PEN PRESSURE
30g = 0
#PEN PRESSURE
60g = 0
#ADJUST / CUT
PEN PRESSURE <ent>
#PEN PRESSURE
100g = 0
#PEN PRESSURE
200g = 0
[] / []
#LANDING
DOWN LANDING = 0
#ADJUST / CUT
LANDING <ent>
#LANDING
UP = 0 END = 0g
Switching to cut landing
adjustment
[FEED]: Returns to PEN landing adjustment
[END]: MENU
#PHOTO SENSOR
SENSOR LV. <ent>
#PHOTO SENS./ LV.
OUT: 0000 IN: 0000
#ADJUST / CUT
PHOTO SENSOR <ent>
[] / []
[] / []
#PHOTO SENSOR
POSITION <ent>
#PHOTOsens./POSITION
START :ent
#PHOTOsens./POSITION
X = 0.0 Y = 0.0
[] / []
#PEN PRESSURE
400g = 0
#ADJUST
GR/PR POSITION <ent>
#GR/PR POSITION
CUTTER SCOOTING :ent
LEVER UP SET:PR POSITION
LEVER DOWN
#GR/PR POSITION
ACTION :ent
failure
Lever DOWNLever UP
To the next step when it is already
at maintenance position
When self-adjustment fails
#ADJUST
MOTOR CURRENT <ent>
[] / []
#MOTOR CURRENT
STOP ADJUST <ent>
X = 140 Y = 140
( 0 ) ( 0 )
[] / []
#MOTOR CURRENT
X MOVING ADJUT <ent>
#X MOVING ADJUT
S=10 A=0.10 X=100
#X MOVING ADJUT
140 ( 0 )
[] / []
#MOTOR CURRENT
Y MOVING ADJUT <ent>
#Y MOVING ADJUT
S=50 A=0.10 X=100
#Y MOVING ADJUT
140 ( 0 )
[] / []
#ADJUST
SERIAL No. <ent>
[] / []
#SERIAL No.
00000000
#ADJUST
DEALER No. <ent>
[] / []
#DEALER No.
00000000
Drawing &
self-adjustment
To the next step when the
lever is in the UP position
PRINT/CUT POS.
ORIGIN SET :ent
#ADJUST
PRINT/CUT POS. <ent>
PRINT/CUT POS.
Y = 0.0 X = 0.0
[] / []
Print & Pen drawing
Displace the origin to the left 30 mm
or more by operating JOG keys.
Set the pen tip to the origin of the
print result by operating JOG keys.
#LANDING
UP POSITION = 0
[ENTER] / [END], [UTYPE] : Returns
#LANDING / CUT
DOWN LANDING = 0
[UTYPE]
[FEED]
To Next Page
Loading...
Need help?
General