Using the right or left buttons, move to the next tire position you wish to monitor.
Again you will have a red light which will turn green. Repeat this procedure until
you have installed all the transmitters.
You must now EXIT from the “L” mode. Press and hold the right and left buttons
until the 22 tires disappear and you see the letter “M” on the screen. You will now
only see those tire positions to which you have “learned” transmitters.
Do not worry about the red light at the top of the screen. That will go away after
the next step.
For slightly more info on the “L” mode, see pages 21 & 22.
To Next Page
Loading...
Need help?
General
